[?]: Lenze servo drive 9300 parameters

maher · Post by **maher** » Wed Jul 08, 2009 8:13 pm

Hi all
i am trying to find any information to illustrate the whole of parameters of this type of lenze drive

i need to use servo lenze drive 9300 to make a homing for the motor

how can i do it ?
best regards

MAHER

maher · Post by **maher** » Thu Jul 09, 2009 7:24 pm

what can i do?

i am disappoint about this drive

MAHER

EuGrach · Post by **EuGrach** » Fri Jul 10, 2009 1:12 am

Technical documentation:
http://www.lenze.com/downloadbereich/en/_start.htm

Software:
http://www.lenze.com/lenze.com_en_activ ... h=download

I am use "Global Drive Control" PC software for easy commissioning of Global Drive frequency inverters

taube · Post by **taube** » Fri Feb 12, 2010 7:48 am

EuGrach wrote:Technical documentation:
http://www.lenze.com/downloadbereich/en/_start.htm

Software:
http://www.lenze.com/lenze.com_en_activ ... h=download

I am use "Global Drive Control" PC software for easy commissioning of Global Drive frequency inverters

how you connect pc to servo?

sventek · Post by **sventek** » Fri Feb 19, 2010 10:50 am

Hi!

Either you use LECOM A/B or CAN interface. Both are distributed only by Lenze.

Greetings
sventek

EuGrach · Post by **EuGrach** » Sat Feb 20, 2010 10:36 pm

taube wrote: how you connect pc to servo?

using Lecom module:

PLCforum.uz.ua

[?]: Lenze servo drive 9300 parameters

[?]: Lenze servo drive 9300 parameters

Re:

Re: [?]: Lenze servo drive 9300 parameters

Re: Re: