Somebody can help me with a problem:
There is a drive of handle of the stepper motor s.b.c. LVD 10
Has gathered as prescribed by the instruction on maintenance the communication cable of the computer with the drive,
has installed the software of configurator PC2LVD,
has hooked up a cable,
has installed port parametres as under the exposition,
but the computer does not see the drive.
Tried to use interface RS 485 through the converter, but the same effect.
Somebody can worked with these drives, prompt arrangement of soldered connections of a cable and communication parametres.
Matter becomes complicated that there is no console for programming of parametres and so link with the panel goes both on 422 and on 485 interface.
The console on rig ESA VT170W.
I hope somebody will respond, I look forward to hearing.
.