Hi all.
i have 1 project to link 3 Q series plc together.
1st plc is the master and PLC 2 & 3 slave.
---- 1 ) only 20 I/O(x20-x39, y20-y39) and 10 Data memory (DM 0-9 ) willbe link to PLC 1st form PLC 2. ( 15m to PLC1)
---- 2 ) only 30 I/O(x20-x49, y20-y49) and 20 Data memory (DM 0-19 ) willbe link to PLC 1st form PLC 3. (25m to PLC1)
-- IF plc 1 down. PLC 2& 3 still can run but detect error (master down)
-- IF plc 2 or 3 down. PLC 1 and (2 or 3) still can run but detect error (slave down)
What is the best and easy way to link this system.
Using cc-link. rs485 and melsecnet/h ( to Expensive). or have other way
[LINK]: Q series PLC link system
-
- Posts: 39
- Joined: Sun Aug 16, 2009 3:16 pm
- Location: Malaysia
-
- Posts: 39
- Joined: Sun Aug 16, 2009 3:16 pm
- Location: Malaysia
Re: Q series PLC link system
hi Oldman.
thank for reply.
cc-link can link data? how.
how about the data speed.
and how about if PLC 2 down. the master can slave 3 still can run?
thank for reply.
cc-link can link data? how.
how about the data speed.
and how about if PLC 2 down. the master can slave 3 still can run?
-
- Posts: 797
- Joined: Tue Aug 21, 2007 7:05 am
-
- Posts: 39
- Joined: Sun Aug 16, 2009 3:16 pm
- Location: Malaysia
Re: Q series PLC link system
hi Oldman.
thank for share. but im planning want use gx developer. but your share file using IEC.
can i convert IEC to GX ladder.
or can u share gx ladder program for cc-link. link the data.
thank for share. but im planning want use gx developer. but your share file using IEC.
can i convert IEC to GX ladder.
or can u share gx ladder program for cc-link. link the data.
-
- Posts: 797
- Joined: Tue Aug 21, 2007 7:05 am
-
- Posts: 39
- Joined: Sun Aug 16, 2009 3:16 pm
- Location: Malaysia
Re: Q series PLC link system
thank Q Oldman.Oldman wrote:http://www.megaupload.com/?d=X2W2I85D good luck
-
- Posts: 23
- Joined: Fri May 18, 2007 8:44 pm
- Location: United Kingdom
Re: [LINK]: Q series PLC link system
thx Oldman
-
- Posts: 797
- Joined: Tue Aug 21, 2007 7:05 am
-
- Posts: 797
- Joined: Tue Aug 21, 2007 7:05 am