[?]: WinCC Flexible 2008 on Panel PC embedded XP

[ThermoNuclear]

Hi,

I installed WinCC Flex 2008 on a $iemen$ Panel PC with XP embedded as the OS.

After i installed the keys with EKB (4096 Tags) but WinCC Flex stays in DEMO mode .

I have the same problem with another PanelPC with a SimanticNet Lean version on it.

Does anyone have a solution.

PS. the install procedure for the embeded XP (unprotect the flashdisk) has also been done.

Please help , this is driving me crazy...


Kind regards

ThermoNuclear

[CoMod]

PS. the install procedure for the embeded XP (unprotect the flashdisk) has also been done.

http://support.automation.siemens.com/W ... n/40237764

ALM also installed ?
What it show ?
http://support.automation.siemens.com/W ... n/23499546

[ThermoNuclear]

Hi ,

ALM V4.0 is installed on the Panel.

Tried to install the license with EKB locally on the Panel -> no luck.
Tried to install on a PG with EKB , than transfer with ALM over the network to the Panel -> no luck.

On the panel i can not see the AX NF ZZ dir for some reasone and EKB says the license is installed.(system dirs are made visible in ControlPanel)

On the panel a textbox with the message that there is no license for WinCC flex keeps
appearing every 5 min. or so.

Please help.

ThermoNuclear

[CoMod]

How about USB stick with key?

[ThermoNuclear]

Hi ,

also tried with license on USB Stick -> no luck

[CoMod]

Show photoscreen with ALM