[?]: problem with upload configuration s7-315 2dp to PG

[maher]

Hallo

I was trying to upload the program from cpu siemens s7-315 2dp with profibus network but during the uploading process the follwing message was appeared

( uploading station to PG (13:77))

[ (2000) error while uploading the configuration to the programming device (PG) .
do you want to continue? ]

after continuing for uploading i opened the hardware configuration but i found only the empty network ( without drives or any device )


so what can i do ?

best regards

Maher

[Homeroid_BL]

Check adapter and connection parameters.

[Umencho]

Hello,

I suggest to investigate to find what kind of software you don't have installed on your computer. I think this is DriveES basic. Rnf:lblSmileyTooltip_ think ...

13:77 means -
while interpreting SDBs uploaded from the module an error was recognized in the PD...

Best regards,
Umencho

[maher]

Hi Umencho

i have two cpu s7 315-2dp connected in the same profibus ,

according to your opinion , i installed the DRIVE ES ( HF1_zu_DriveES_Basic_V5.1SP1 )

after that i could make uploading for one of these cpu which is connected ( master drive, ES200 )

but the second cpu when i tried to upload it the previous message is appeared again
so what is the reason for it ?

best regards
Maher

[Umencho]

Are both CPU the same? Means the profibus networks content the same drives and ET200S modules. If yes could be the version of Drive ES Basic is lower then the one which was used there. If no, give details what do you have connected there?

Best regards,
Umencho

[maher]

Hi
the uploaded cpu connected with [ profibus2 ( masterdrives , ET200S STANDARD ) AND MPI ( CONNECTED with the second cpu which has the same type )

the second the cpu connected with [ profibus1 ( ET200S STANDARD , MICROMASTERS 440, HMI SIEMENS )]

OK

regards

Maher

[maher]

what is your opinion Umencho?

regards
Maher

[maher]

Please i need help