[?]: Going online CQM1H-CPU51

[maher]

Hi all

please can any one show me pin out for cable to conncet the pc to CQM1H-cpu51???

Best regards
Maher

[cuervo2k]

[maher]

Hi all
it is the first time for me to use PLC OMRON type ( CQM1H-CPU51):
I am working by CX programmer 8.1 , and the cable which assigned in this site ,
but i remarked that when i am trying to online the program doesn't show this PLC type and the connection would be failed ,

After that i make updating for the program to CX-programmer v8.33 ,:
and trying again to go online but the following window are appeared _

i am trying to establish the connection between the pc and the plc by the PRPHL. port ( by using the previous assigned cable )

auto online searching :
plc: CS , CJ , CP series , CV series
communication : com3, 115200,none,8,1
protocol: toolbus

is this program not supported ( CQM1H-CPU51 ) type ?
why tell me why?


so please tell me how can i go online for this plc ?, and uploading the software from the plc.

Best regards
Maher

[maher]

Please no time
I wait the reply urgently

Best regards
Maher

[maher]

Hi

Please i want to know if the previous connection is suitable for this type of cpu51 or , it will need adapter ?????

please i am in bad need of the reply urgently

Best regards
Maher

[intruder001]

Hi!
Try this manual:
http://www.scribd.com/doc/19849594/Omron-CQM1-Manual
Have a nice day!

[Homeroid_BL]

With cables shown, you can use ONLY RS232 port on CQM1H.