Request: 800xA Course T305

[Dlop]

Hi guys:

Do you have T305 of 800xA system course ? or any information about 800xA installation?

Thanks in advance!!!

[Linkinx64]

800xA installation DVD contains installation wizard that provides:
1. Windows components preconfiguration, required runtime install
2. 800xA components selection and installation (according to selected node type or manually)
3. Basic system (step-by-step) creation, configuration and launch.

What else you need to install 800xA successfully?
I've never read the T305 but think it is not helpful in case of some specific errors occured during or after install, there's no ABB knowledge base yet created.

Regards, Linkinx64

[Dlop]

My doubt is about the installation in simple node. Because after install the system base, I installed the add-on process grafics 2, After this I can't enter to e-Plant and then freeze the window of e-plan.

Do you have a any manual about this installation? because in the manuals of 800xA system are very large.

I do the installation with the Automated Installation of the system.

Greetings!!!!

800xA installation DVD contains installation wizard that provides:
1. Windows components preconfiguration, required runtime install
2. 800xA components selection and installation (according to selected node type or manually)
3. Basic system (step-by-step) creation, configuration and launch.

What else you need to install 800xA successfully?
I've never read the T305 but think it is not helpful in case of some specific errors occured during or after install, there's no ABB knowledge base yet created.

Regards, Linkinx64

[Linkinx64]

after install the system base, I installed the add-on process grafics 2, After this I can't enter to e-Plant and then freeze the window of e-plan.

Which version of SV5 you used? Put more info about your 800xA installation and target system (Windows, IE version, etc)
Advice: Try install SV5.0 SP2 with NO ROLLUPS.
Then install Rollup 3h only for 800xA Base.
After this - process graphics + rollup 2a for Process Graphics.
DO NOT upgrade AC 800M Connect and Asset Optimization.

I will create my 800xA installation manual (based on experience, with solution about errors that may occur at 800xA setup stage) and publish here as soon as finish writing.

Regards, Linkinx64

[SOULHACK]

Hi:

Do you have any information about 800xA system and ABB MASTER course ? or any information about ABB MASTER course A330?

Thanks in advance!!!