[?]: CP1H X CONTROL STEP MOTOR

[daiphongsk]

I have CPU CP1H X, GMD 04 drives (RTA) for control step motor.
Can you tell me how can do it.
i have tried with PULS, SPED or ACC , the motor run slowly at 2600 fulse frequecyand i increase fulse frequecy so it did not run
This is my programme http://www.mediafire.com/?cwfrn7p9koer7r2
thanks a lot!

[rogeron]

Hello,

To get started in your program you did not provide for indexing cycle and the API parameters are the speed to zero.

I advise you to use the function block for typical use, it is very well documented in the help.