[reLink]: ABB 800xA simulator

[samsweden]

Hi guys,

I am sam,

I am doing my masters in electrical engineering. While searching for master thesis i came to know about ABB 800xA simulator.
h[url]ttp://www.abb.com/product/seitp334/a5beb9cb23 ... 36e07.aspx[/url]
I would like to know whether is it possible for doing a master thesis using 800xA. I tried to install the 800xA system and the simulator.
I couldnt able to install it.

It would be helpful for me if you guys give me any ideas to proceed with my thesis.

If it is possible to do,

can you guys leave me a link where i can download the required software to install, will be helpful for me.

Thanks in advance.

[Linkinx64]

You probably need to visit the follow topics:

viewtopic.php?f=43&t=7391

viewtopic.php?f=3&t=12113

[samsweden]

Hi Linkinx64,

Thanks for the links.

[samsweden]

Hi Linkinx64,

I order to develop 10MW Power Plant using 800xa simulator, what kind of set up do I need for 800xa simulator.

Thanks in advance,

Sam.

[Linkinx64]

Hi, Sam

I didn't work with ABB training simulator yet.
But I think, 800xA settings depend rather on amount and type of functions handled by 800xA System on your plant, than on power production/consumption.
That can be either single-controller system or whole automation network with multiple nodes and different interfaces. You may use asset optimisation/data logging/link with MES system (etc.) or you may not - it's up to you: 800xA is a wide-scalable system.

Regards, Linkinx64

[samsweden]

Hi Linkinx64,

Thanks for the suggestion,

I would like to ask you one more question, for my master thesis I am going to develop 10MW biomass power plant and I would like to simulate the operation of this power plant with 800xA simulator, basically on power production with single controller system. Could you give me some ideas specifically for the plant operation monitoring and controlling. For this what kind of setup should I look for? Please if you have any suggestion let me know.

Thanks,

Regards,
Sam.