[?]: AC800M bits problem

другие контроллеры
Dlop
Posts: 28
Joined: Tue Oct 19, 2010 5:59 pm

[?]: AC800M bits problem

Post by Dlop »

Hi guys

I have a problem with ControlBuilder M For 800xA, In this case I have a UMC 22 with Profibus DP.
I have the next words :
Word 1, Control word (Foward, Run, Reverse, Reset Etc)
Word 2, Status word (Fault, Running etc)
word 3, Current Motor.

I want to use bits for these words, for example : UMC 22.ControlWord.0=1; (In this case I want to use the bit 0 of control word 1to run the UMC). But the control builder M displays me the next message "Identifiers must start with a letter o undescore 0".

Any Idea?
(h)