Hello,
It is my first time to work with NUM software and hardware.
My first question is about Ethernet communication between NUM 1080 T and my PC.
I suppose it should be something with NC parameter P100 and P101.
When i try to ping the connection sometimes its ok, sometimes it is not...
My other question is about initialisation, I have downloaded parameters .XPA file that was initialised with SETTOOL but after that i see on panel Missing axis, Do you want to continue Y/N?
Any suggestions what could be wrong?
Number of axis and their configuration is ok.
Does anyone has some experience with NUM?
Best regards, Taubek.
[?]: NUM CNC for first time
-
- Posts: 1
- Joined: Wed Jan 07, 2015 11:38 pm
Re: [?]: NUM CNC for first time
Hello taubek,
your message : "Missing axis, Do you want to continue Y/N?" is print on the panel because you don't have connect the sub-d25 connector for the encoder and speed command for all axis. Note : in this connector there are shunt for the axis codage. See integrated manual for num 1000 serie.
good luck
your message : "Missing axis, Do you want to continue Y/N?" is print on the panel because you don't have connect the sub-d25 connector for the encoder and speed command for all axis. Note : in this connector there are shunt for the axis codage. See integrated manual for num 1000 serie.
good luck