Request: Micro PanelMate Configuration Editor

[tintin2005]

hello everybody.

I am looking for this old software to program these olg message displays from cutler hammer. it is a ms-dos software ...
i think it´s called " Micro PanelMate Configuration Editor ". I can´t find it nowhere.
is there anybody that has got it?
I have some of this old message displays and i would like to make them useful.

here there´s some information about these displays....

http://www.eaton.com/ecm/groups/public/ ... 030256.pdf
So, i´ll be thankful if someone could send it to me.

thanks in advance

from portugal

tintin2005

[tintin2005]

Hello!

Anyone found the required software in the last post?

regards

[jagmohan]

ANYONE HAS CUTLER HAMMER PANELMATE POWERPRO HMI SOFTWARE ?