Request: ABB DCS500

Macsuco · Post by **Macsuco** » Thu Dec 01, 2011 7:42 pm

Hi Everyone!
I am new to this site.

I want to configure ABB's DCS500 DC drive using my PC. Can any one help me with the right tool or tools?

Thanks.

brave_eagle · Post by **brave_eagle** » Fri Dec 02, 2011 1:17 am

them should be DDCTool and GADTool

Macsuco · Post by **Macsuco** » Mon Dec 05, 2011 7:27 pm

Thanks a lot!

But, here is another question. Can I get them free or do I need to purchase? If the answer is YES, then tell me the right place. (fback)

Thanks again.

SOULHACK · Post by **SOULHACK** » Tue Dec 06, 2011 1:55 am

Hey man, if you want to use your PC you need to install PCMCIA SNAT 624 card, SNAT 622 card, SNAT 608 isa board.

Regards
SoulHack

PLCforum.uz.ua