dear everyone!
i have a fatek program for controll cut off machine ( machine for corrugated line) , i can not understand this program. now HMI brockendown i can not make inteface program . Please help me find some function block in program.( example counter, set value for lenght, set value for counter ...) i description some function for interface i knew.
- set value lenght ( input lenght)
- set value quantity ( input quantity)
- Display speed line
- display curent value of quantity ( couterup)
- display curent of lenght cutting..
program please see in link http://www.4shared.com/rar/gf-jEG-0/Windows.html ( PLC Fatek FBs - 10MAT).
Thanks
how to understand fatek progam ?
-
- Posts: 96
- Joined: Fri Nov 16, 2007 3:18 pm
- Location: Europe
Re: how to understand fatek progam ?
Could you upload your project on different host?
-
- Posts: 3
- Joined: Mon Oct 08, 2012 12:20 pm
Re: how to understand fatek progam ?
dear Kriztof.
Please see the link. I upload a program file & an interface file . but interface i rwiting by vietnamese language . i'll upload interface file by english . pl help me modify.
http://www.mediafire.com/?1sxb2s5ddd847in
http://www.mediafire.com/?66zg1dda33gblfk
http://www.mediafire.com/?5dbwdsn64asuq66
Please see the link. I upload a program file & an interface file . but interface i rwiting by vietnamese language . i'll upload interface file by english . pl help me modify.
http://www.mediafire.com/?1sxb2s5ddd847in
http://www.mediafire.com/?66zg1dda33gblfk
http://www.mediafire.com/?5dbwdsn64asuq66
-
- Posts: 96
- Joined: Fri Nov 16, 2007 3:18 pm
- Location: Europe
Re: how to understand fatek progam ?
Without source project and electrical diagrams and with zero knowledge about machine it's difficult to completely understand this program
Do you have some information about this machine e.g. manual, operator instruction, safety instruction etc.
Your machine is equipped with Weintek HMI panel.
Did you check PLC memory addresses using EasyBuilder application?
In this way you can see what registers/markers are used as machine parameters.
Do you have some information about this machine e.g. manual, operator instruction, safety instruction etc.
Your machine is equipped with Weintek HMI panel.
Did you check PLC memory addresses using EasyBuilder application?
In this way you can see what registers/markers are used as machine parameters.