800xA: Single node status

другие контроллеры
rodomb
Posts: 14
Joined: Sun Aug 26, 2012 12:19 am

800xA: Single node status

Post by rodomb »

Hi,
I am beginner in 800xA ... and have request :)
I installed single node with software controller.
You can see that computer status for my single node is bad.

Image

How can I solve this problem? Is it important for functionality my single node?

Thanx for help

Best regards
Roman
Linkinx64
Posts: 894
Joined: Sun Apr 11, 2010 3:00 am
Location: Russia

Re: 800xA: Single node status

Post by Linkinx64 »

First you should answer the question: for which purpose did you load "PC Network and Software Monitoring" system extension into your system?
Then I can answer whether "Bad" status is important for your system or not.
Linkinx64
Posts: 894
Joined: Sun Apr 11, 2010 3:00 am
Location: Russia

Re: 800xA: Single node status

Post by Linkinx64 »

Check OPC Data Source definition aspect in the IT OPC Server network that it is connected to the service group (default "SG_IT Server")
If OPC Data Source definition aspect is configured - go to "IT Device Manager" aspect of your node object (800ENGNODE). Click "Populate" and recheck node status.
rodomb
Posts: 14
Joined: Sun Aug 26, 2012 12:19 am

Re: 800xA: Single node status

Post by rodomb »

Linkinx64 wrote:First you should answer the question: for which purpose did you load "PC Network and Software Monitoring" system extension into your system?
Then I can answer whether "Bad" status is important for your system or not.
Thx for answer. Linkinx64 you are invaluable.
It is my single node installed on virtual machine for training so I installed many extensions ...
rodomb
Posts: 14
Joined: Sun Aug 26, 2012 12:19 am

Re: 800xA: Single node status

Post by rodomb »

Linkinx64 wrote:Check OPC Data Source definition aspect in the IT OPC Server network that it is connected to the service group (default "SG_IT Server")
I think that service is configured properly

Image
Linkinx64 wrote:If OPC Data Source definition aspect is configured - go to "IT Device Manager" aspect of your node object (800ENGNODE). Click "Populate" and recheck node status.
I clicked "Populate"
Image

but computer status on faceplate still is bad
Image

but Device status probably is OK (green colour)??
Image

thx for help