Spoiler
Show
Help on Message 288:47
Description of Error:
There is no access to the module via the online interface set with "Setting the PG/PC Interface". For example, you can only address a module via the PROFIBUS interface if the programmable controller has access to a PROFIBUS network.
To Correct or Avoid Error:
Check whether the online interface is set correctly. Check the settings as required.
Check whether the station in which the module is located is configured correctly. Change the configuration if necessary.
Description of Error:
There is no access to the module via the online interface set with "Setting the PG/PC Interface". For example, you can only address a module via the PROFIBUS interface if the programmable controller has access to a PROFIBUS network.
To Correct or Avoid Error:
Check whether the online interface is set correctly. Check the settings as required.
Check whether the station in which the module is located is configured correctly. Change the configuration if necessary.
Связь операционной системы (WinXP SP3) с контроллером есть:
Spoiler
Show
Ethernet кабель "прямой":
Spoiler
Show
Spoiler
Show
Что необходимо сделать, чтобы заставить Step7 видеть контроллер?
Прошу изложить доступно и пошагово. Поиск по сайту дает разрозненную информацию
