Hello All,
I am a new student and I really need help in writing a program for Its PLC Palletizer simulation.
We are running with TIA portal and I am having some problems with how to differentiate the size of the box and tell them which off table to go to after they are detected.
If anyone has done this plz help.
Thanks
CD
[?]: Its PLC Program for Palletizer System
-
cdraughter
- Posts: 2
- Joined: Thu Aug 08, 2013 4:17 pm
- Location: louisiana
-
matster
- Posts: 5
- Joined: Sat Jul 27, 2013 3:54 am
Re: [?]: Its PLC Program for Palletizer System
Should be fairly basic if based on height, width or weight.
What are you using to control the size?
What are you're options with where the boxs are moved to? and how are you moving them?
What are you using to control the size?
What are you're options with where the boxs are moved to? and how are you moving them?
-
cdraughter
- Posts: 2
- Joined: Thu Aug 08, 2013 4:17 pm
- Location: louisiana
Re: [?]: Its PLC Program for Palletizer System
Hey Matster,
Sorry for the delay and thanks for the response. I have been swamped with finals. It only height and there are two input sensors stacked on top of each other the detect high box and low box. Then its sent to a turntable and each height should be sent down opposite exit conveyors. Im really struggling. The software is called Its PLC professional software and we are using siemens S7 1200 to run it.
Thanks so much!
Sorry for the delay and thanks for the response. I have been swamped with finals. It only height and there are two input sensors stacked on top of each other the detect high box and low box. Then its sent to a turntable and each height should be sent down opposite exit conveyors. Im really struggling. The software is called Its PLC professional software and we are using siemens S7 1200 to run it.
Thanks so much!