Serad Supervisor 640 CANOpen configuration

dit_is_mijn_naam · Post by **dit_is_mijn_naam** » Fri Mar 28, 2014 12:43 pm

Hello all,

I have a Serad Supervisor 640 HMI/PLC.

I want to setup a CANopen bus to a telemecanique lexium 05.

Only the manual is not very clear in how this must done. There is only a explanation of each command, and not in wich order to use. The manual is a very poor translation from Frenchto English. So there are parts in de manual that are stil in French

Also the people at Serad are not very willing to help either.

So, is there someone that has some knowledge of how to configurate and setup a CANopen bus with a supervisor 640? Or can give me a part of the program task to setup the CANopen

Many thanks, Mark