A>I am a fresher to siemens step7 .
I have installed TIA portal v13 in my laptop .
We have a customer who is having Simatic s7 1200 controller so I need to upload the program from the device.
The problem is customer have no idea who downloaded or which version of step 7 used for programming the device.
My question is if i upload the program with TIA portal v13 any errors will come up or how can i upload the program.
B> Whenver I am opening the TIA portal v13 ( installed in Windows 8 ) I am getting one error message " following assemblies not found .....
Hi experts
I am new to siemens so looking for advice on the following issues
I have a plc -S7 1200 which is running at site
we dont have any backup or software for the same so I downloaded TIA portal v13 from siemens site then I connected the PLC and I was able to go online but while uploading the program I got an error message " preconditions are not met" so I checked the diagnostics and it was displaying version missmatch ( configuation in control is tia portal v11 ) so I tried to get a tia portal v11 trial from internet but no success is there any way to sort out this
It would b helpful if any can send the link for tia portal v11
maybe this will help to you
(FAQ: In STEP 7 (TIA Portal) V13 SP1, how do you load project data from a device that has been configured with STEP 7 (TIA Portal) V12 or V13?) https://support.automation.siemens.com/ ... d=82169157
I have installed TIA portal v12 SP1 so when I tried to upload from the controller (S71200) I got error " Project inside controller is v11 and incompatible etc) So I downloaded the compatibility mode project from siemens support site and uploaded successfully now my doubt is whether I can easily download with my current software TIA Portal v12sp1 without any error or I should get V11..