Hi guys,
I found people on this forum more knowledgeable than anywhere else.
I am a new guy in AB world so I need some of your advice.
This is what I am looking for.
What I have is few of Allen Bradley servo drives Kinetix 6000 with both sercos 6200 and ethernet based modules 6500. -m and -s at the end of the part number. I also have one MPL multiturn high resolution encoder, also I have a rail with few slot fillers.
What else (hardware and software) I need so I can jog this motor, clock and counter clockwise, I do not need any I/O's or coclpex motion tasks.
For that simple operation do I need anything connected to I/O connector?
What software I can use?
Do I need ethernet module or sercos module 1756 or I can run this as standalone drive?
Any help would be appreciated.
Many thanks