I want get data like IA,IB,IC.......MWh from sel351s relay as slave to yokogawa dcs (centum vp) via Modbus RTU. I connected online with sel-351s relay and I did not find the Modbus protocol only I found SEL,DNP,MBB....., I had that you can set any serial interface of that relay to any protocol like sel,dnp,mbb,mb ..... using command line. I did try to set EIA-485 to use Modbus RTU doing things like this: Login on command line with level 2 and write the command:
=>> SET P 1 end press enter is accept and is give the protocol list (SEL,DNP,MB,MBB,MB8B ..) but there is no the Modbus, I force to set MOD is showing message: Out of range!!
Could you help how to enable the Modbus RTU protocol at SEL-351s serial port EIA-485 to use Modbus Protocol????
Enable modbus protocol at serial EIA-485 Sel-351s relay
-
- Posts: 5
- Joined: Wed Jul 16, 2014 10:56 am
-
- Posts: 5
- Joined: Wed Jul 16, 2014 10:56 am
Re: Enable modbus protocol at serial EIA-485 Sel-351s relay
Hi, there is the firmware version and the accelerator but I am not succeed to upload the image.
AcSELerator QuickSet 6.1.3.2
Firmware version (Part Number: 0351s 6**4**8*21 according to Divice Part Number) or using command line: FID=SEL-351S-6-R400-V0-Z008006-D20070117.
I would like to post the image screen but I fail to do that, but please keep help to get the solution.
regards
AcSELerator QuickSet 6.1.3.2
Firmware version (Part Number: 0351s 6**4**8*21 according to Divice Part Number) or using command line: FID=SEL-351S-6-R400-V0-Z008006-D20070117.
I would like to post the image screen but I fail to do that, but please keep help to get the solution.
regards
-
- Posts: 5
- Joined: Wed Jul 16, 2014 10:56 am
Re: Enable modbus protocol at serial EIA-485 Sel-351s relay
[img]E:\Acselerator1.gif[/img]