ELAU Pacdrive mc-4/11/10/400 diagnotic port X7

другие контроллеры
ttzo
Posts: 1
Joined: Mon Apr 04, 2016 6:00 pm

ELAU Pacdrive mc-4/11/10/400 diagnotic port X7

Post by ttzo »

i give 24volt only X1,pin1 and GND X1,PIN2
i have use cable according
The Communication Cable for the Diagnosic Port (MC-4 X7) is 15154304-030,
However the Reference 15154304-030 is obsolete and replaced by the Reference VW3E3057R030, PROGRAMMING CABLE MC 4, 3,0M
Additionally, find attached the Pin Assignment of the Programming Cable (Both cables VW3E3057R030 & 15154304-030 are having the same
configuration).
Mini-Din 6-pol. ST -------------D-Sub 9-pol. BU
1,4 =gnd ---------------------------5
2=RxD-----------------------------3=TxD
3=TxD----------------------------2RxD
so ask
1)this port X7 is only for firmware ?
2)for diagnostics software the correct port is?
3) need hardware enable 24 volt to X1,4?
i need all connections a) about firmware and b) about diagnostic
also axis switch any position?
also ask about service mode how to?