IEC FOR concept2.6xl

[ahmad_maheri]

hello
when i want upload a poroject from my plc ( my cpu : pc-e984-285) with concept 2.6 xl it say to me this mess : uploading IEC program setction has been disabled , because there is either no IEC upload information in the plc or the opened project is not empty .. so what is problem? pleas help to me

[SE_support]

Hello Ahmad,

just open in Concept the plc selection menu, on the left side you select the plc type and in the right side you can enable/disable IEC support

[ahmad_maheri]

hi friend...
thanks for your answer ... yes i know but when i upload program from plc to laptop just load hardware cofiguration and program dont load in laptop...what should i do... pleas help to me

[Schtiel]

If IEC upload information was not included by the PLC programmer, you can't upload it from PLC

[SE_support]

oh, sorry, just now I saw that you are asking about upload from PLC.
Schtiel has right, if no upload info on the plc, then you can't upload it

[ahmad_maheri]

I am looking for a solution for upload IEC section when my program dont let to me upload them

[ahmad_maheri]

Is not any solution,?i am hurry

[Schtiel]

You can't upload information if it was't downloaded. There is nothing to upload, no upload information.

[ahmad_maheri]

hi thanks for your answer
there are two method for download program to modicon plcs :
1- with permit upload IEC section upload>>>> i can upload IEC section
2- no permit upload IEC section upload>>>> i cant upload IEC section but IEC section information come to my laptop in othere language such az asmbely

now i have problem with 2.... cuz programer didnot permit for upload the IEC section

i am looking for a solution