). Is there anywhere I can down load it from so that I can upgrade an old project to winCC Flex 2008? I have my Protool 6.0 SP3 Disk. The project has protocol 6.0 sp3 HMI, PDiag and Step7 5.5 content.
Thanks,
Gazzap.
Problems installing Protool 6.0 SP3 for upgrading a project.
-
gazzap
- Posts: 10
- Joined: Mon Sep 27, 2010 9:28 pm
Problems installing Protool 6.0 SP3 for upgrading a project.
I have a problem. I had a clean out and now cannot find my Protool 6.0 CD (probably thought I would never need it again!! ).
Is there anywhere I can down load it from so that I can upgrade an old project to winCC Flex 2008? I have my Protool 6.0 SP3 Disk. The project has protocol 6.0 sp3 HMI, PDiag and Step7 5.5 content.
Thanks,
Gazzap.
). Is there anywhere I can down load it from so that I can upgrade an old project to winCC Flex 2008? I have my Protool 6.0 SP3 Disk. The project has protocol 6.0 sp3 HMI, PDiag and Step7 5.5 content.
Thanks,
Gazzap.
-
Schtiel
- Site Admin
- Posts: 1122
- Joined: Wed Sep 06, 2006 12:03 pm
- Location: CIS
Have you checked this topic?