WinCC With GE Fanuc IC693CPU351

другие контроллеры
hanzalh
Posts: 13
Joined: Wed Jul 22, 2015 6:57 pm

WinCC With GE Fanuc IC693CPU351

Post by hanzalh »

Dear all,

I want to ask about how to get the buss address from this module to stablish the connection between PLC and Wincc ,the Rar file contains Pictures described as the following :

1- Describes PC to PLC Connection.
2- Describes PLC Connection Config.
3- Describes PC Connection Config.
4- Describes Wincc Connection Config.
5,6- PLC Connection interface details.

I think the whole problem is to get the bus address from GE Fanuc PLC as this is my first time to deal with this time of PLC and if there is any one here can help me in this issue this will be helpful ,and if there is any thing wrong in the connection or in the configuration please tell me I think with these Pictures may be fullfil the all requirements and if there is any thing else required to explain any thing not clear to you please ask.

The down load link of the RAR file as following:
(http://www.4shared.com/zip/sppMd_k_ce/G ... ction.html)

Best Regards,
Mahmoud Hazem
hanzalh
Posts: 13
Joined: Wed Jul 22, 2015 6:57 pm

Re: WinCC With GE Fanuc IC693CPU351

Post by hanzalh »

Dear all,

Any Update ?
hanzalh
Posts: 13
Joined: Wed Jul 22, 2015 6:57 pm

Re: WinCC With GE Fanuc IC693CPU351

Post by hanzalh »

Dear all,

Any Update ?

Best Regards,
Mahmoud Hazem