after I place components, the new A999 shows up with red dot infront.
Why does this happend ?
Pro Panel help
-
luuxiii
- Posts: 5
- Joined: Wed Nov 07, 2012 11:02 pm
Pro Panel help
I place a components from 3D Mounting layout (eg. A999)
after I place components, the new A999 shows up with red dot infront.
Why does this happend ?
after I place components, the new A999 shows up with red dot infront.
Why does this happend ?
-
lin2m3
- Posts: 8
- Joined: Fri May 30, 2014 12:31 pm
Re: Pro Panel help
Be sure you have unique DT on every part and Ful DT field filled. If your part has more sub-parts, either you unite them or define them with a unique DT(Full DT). Red dot shows you have an error in the project from the view point of Propanel.
-
luuxiii
- Posts: 5
- Joined: Wed Nov 07, 2012 11:02 pm
Re: Pro Panel help
Thank you very much. I'll take a look in this matterlin2m3 wrote:Be sure you have unique DT on every part and Ful DT field filled. If your part has more sub-parts, either you unite them or define them with a unique DT(Full DT). Red dot shows you have an error in the project from the view point of Propanel.
