Eaton Easy PRO Between 6.90 and 6.96 need?

другие контроллеры
Raptor
Posts: 46
Joined: Sat May 02, 2015 8:45 am

Eaton Easy PRO Between 6.90 and 6.96 need?

Post by Raptor »

Hello Dear friends. I need Eaton Easy PRO 6.90 or 6.96 , intelligent relay software. Plase if you have : can you share for we? Please full. (for relays Eaton Easy 200, 400, 500, 700 and 800)
I think Eaton and Moeller are using the same software

Software link:
http://applications.eaton.eu/sdlc?LX=11 ... 74&f3=1185

Image

Image

Image
PLC cable Eaton EASY-USB-CAB 107926


Software
Multi-lingual programming
Hardware selection screen
Simple drag and drop circuit diagram drawing editor
Control circuit configuration tools
Offline simulation
Online Commissioning
Suitable for running under Windows NT SP6, 2000 SP4, XP SP1 and 7 (32/64Bit)
Last edited by Raptor on Fri Jun 01, 2018 7:51 pm, edited 2 times in total.
AlekMalek
Posts: 39
Joined: Wed Mar 27, 2013 2:37 pm

Re: Eaton Easy PRO Between 6.90 and 6.95 need?

Post by AlekMalek »

I have software for them. And yes, they are programming from the same software. More over ABB controllers also could be programmed with this soft.
h4rdw4re
Posts: 86
Joined: Mon Feb 25, 2008 8:40 am
Location: Europe

Re: Eaton Easy PRO Between 6.90 and 6.95 need?

Post by h4rdw4re »

AlekMalek wrote:I have software for them. And yes, they are programming from the same software. More over ABB controllers also could be programmed with this soft.
Can you share it?
Raptor
Posts: 46
Joined: Sat May 02, 2015 8:45 am

Re: Eaton Easy PRO Between 6.90 and 6.95 need?

Post by Raptor »

AlekMalek wrote:I have software for them. And yes, they are programming from the same software. More over ABB controllers also could be programmed with this soft.
if you possible please share it. PM messages or global..
h4rdw4re
Posts: 86
Joined: Mon Feb 25, 2008 8:40 am
Location: Europe

Eaton Easy PRO 6.96.5388

Post by h4rdw4re »

Raptor
Posts: 46
Joined: Sat May 02, 2015 8:45 am

Re: Eaton Easy PRO Between 6.90 and 6.96 need?

Post by Raptor »

Thank you really..