hello everyone
we work on a water station using plc schneider M340 and we should make a communication with a dcs honeywell , this dcs should read a variables from my plc i have a ethernet module BMX NOE 0.100
i put the ip adress but the dcs show that the variables are not online
Urgent communication between Schneider m340 and honeywell
-
- Posts: 6
- Joined: Thu Jul 09, 2015 2:57 pm
-
- Posts: 101
- Joined: Thu Aug 29, 2013 4:11 pm
Re: Urgent communication between Schneider m340 and honeywel
Hi accmpy,
on M340 side you can only setup the IP-address and %MWi variable addresses.
So, if communication doesn't work, then check the IP and %MWi addresses.
on M340 side you can only setup the IP-address and %MWi variable addresses.
So, if communication doesn't work, then check the IP and %MWi addresses.