First of all, I am a beginner in the OMRON PLC and I am carrying out a balance of 300 kg for mill machine.
The attached figure describes the system, initially the balance is empty, the motor M1 starts up to a value of 60 kg then stop.
Then the motor M2 starts up to a value of 100 kg and the same thing for the motor M3, and the M4 motor (40kg).
after a measurement of 300 kg all the motors are stopped, and the OUTPUT1 will open.
the used PLC is CJ2M
Please help how can I programming this balance, and if there is anything to add please tell me.
