How can I readjust siemens motor encoder?(inc. Abs. EnDat.,resolver)
regards,
[?]: siemens servomotor maintenance
-
emos
- Posts: 11
- Joined: Sat Apr 07, 2007 10:56 pm
- Location: Turkey
[?]: siemens servomotor maintenance
Hi,
How can I readjust siemens motor encoder?(inc. Abs. EnDat.,resolver)
regards,
How can I readjust siemens motor encoder?(inc. Abs. EnDat.,resolver)
regards,
-
Umencho
- Posts: 508
- Joined: Mon Jul 16, 2007 12:28 pm
- Location: Europe
Hello
Is "reajust" means change type of encoder? Encoder is connected to the motor and gives "somewhere" info. To read info in right way, in this "somewhere" you assigned parameters of encoder. And now if you need to replace old encoder with new, but the same type - just disconect old and connect new. But if you want to change type (not so often
), must assigned this new parameters in device that will read data.
regards
Is "reajust" means change type of encoder? Encoder is connected to the motor and gives "somewhere" info. To read info in right way, in this "somewhere" you assigned parameters of encoder. And now if you need to replace old encoder with new, but the same type - just disconect old and connect new. But if you want to change type (not so often
), must assigned this new parameters in device that will read data. regards
-
enrique_gf
- Posts: 38
- Joined: Fri May 02, 2008 4:41 am
- Location: Mexico
If you opened the servo and separate the resolver from the motor or the resolver rotor winding from the resolver stator winding, try to match the original location. you should mark the resolver rotor and stator before separating them. If this is what you mean by readjusting if you mean replace well a resolver uses analog voltage, and encoders use digital so you cant use the same servo.