Siemens wrote:The SIMATIC WinAC Basis software and RTX support only the CPs CP5611, CP5611-A2, CP5613 and all versions of CP5613-A2 as IF module.
WinAC Basis and RTX do not support any other CPs as IF module.
The PCMCIA cards CP5511 and CP5512 are not supported either.
If you wish to install WinAC RTX on a Single-Core microprocessor with installed Multiprocessor HAL
and running without Hyperthreading
or with Hyperthreading switched off ,
WinAC RTX will abort installation with the error message
Error wrote:"Unable to install RTX ... Runtime on this system ...".
In this case you must first install a suitable "ACPI Uniprocessor PC" HAL before you can install WinAC RTX.
frankw wrote:CPU load 100%, the process is s7wlpapx.exe, OS is WinXP SP3,
before and after RTX SP1 installation,
what is wrong?
wrong? Need Dual core CPU - one core for WinAC dedicated mode.
Intel® Core™ 2 Duo processor technology with SIMATIC WinAC installation options for SIMATIC WinAC
on SIMATIC PCs with Intel® Core™ 2 Duo processors (shared and dedicated mode).
Performance comparisons for SIMATIC WinAC RTX and SIMATIC WinCC flexible
on an Intel® Core™ 2 Duo processor and a single-core processor.
When installing WinAC RTX 2005 and WinAC RTX 2008 on SIMATIC PCs of the "B" generation with Intel Celeron processor and preinstalled Microsoft Windows XP Professional or XP embedded operating system, the following installation fault occurs...
Last edited by CoMod on Fri Apr 10, 2009 10:20 am, edited 2 times in total.
