[?]: Step7 v5.4 SP3 HF1 + PLCSIM v5.4 no PLCSIM window

graucho · Post by **graucho** » Fri Jan 04, 2008 9:55 pm

I have installed Step7 v5.4 SP3 HF1 and PLCSIM v5.4.
License for this products is Step7 v5.4 Professional.
After I click in Step 7 menu to activate plcsim the window of simulator (for I/O control) is not displayed.
Maybe someone have or had similar problem with this simulator?
I believe that is not problem with license but who knows.

Thanks for any advice.

graucho

robin_hood · Post by **robin_hood** » Mon Jan 07, 2008 7:42 am

install plc 5.4 sp1

Nedjeljko · Post by **Nedjeljko** » Mon Jan 07, 2008 10:10 am

...I have same problem with this...
...do you resolve problem...please tell me how!?

Thanks

Post by **CoMod** » Mon Jan 07, 2008 11:40 am

I don't have this problem
But I switch On of second monitor

Try to reinstall Simatic soft.

in Russian wrote:У меня работает без проблем,
когда не забываю включить второй монитор... (такой анекдот у меня был когда я не мог запустить ECabinet - он зараза по умолчанию выводил диалог установки на второй монитор, который у меня был выключен.)
Попробуй переустановить софт заново.

Nedjeljko · Post by **Nedjeljko** » Mon Jan 07, 2008 12:22 pm

...Im solve problem, I have install PLCsim separetly than Step7...I tough that PLCSim came together with step 7 instalation

HotFix1 for STEP 7 V5.4 SP3 = STEP 7 V5.4 Servicepack 3.1
http://support.automation.siemens.com/W ... e/26578452

graucho · Post by **graucho** » Wed Jan 09, 2008 10:35 am

I have found two solutions.
One: PLCSIM v5.3 (without SP1) and STEP 7 5.4 simultaor works ok
Two: PLCSIM v5.4 with new SP1 (http://support.automation.siemens.com/W ... n/27249219) and it's a live

Regards