[REQUEST]: Eisbaer KNX HMI-Software

[nosti]

Hi All,

I would like to use a HMI in my house. The automation system is a mix between EIB/KNX and a Beckhoff IPC (Twincat) with K-Bus.
I found the HMI-Software Eisbaer KNX at http://www.busbaer.de. It is especially made for Home automation.
There is also an OPC available. I think this is what I need.

Can somebody upload a Keymaker or something else for this?

Thanks!
Nosti

[Nedjeljko]

do you find something about it...
..I think that you need sw-s listed on this site...
http://www.knx.org/downloads-support/downloads/ those sw-s are universal for all devices with KNX (if I understand well)...
...anyone have those sw-s...please

P.S.
...Is anyhow possible to use Simatic HMIs in EIB KNX system..

Is anyone know maybe low cost producer for KNX devices...please?!?