[? +]: PLCSIM Simulation with WinCC

offline_ · Post by **offline_** » Wed Oct 12, 2005 8:35 am

i have project of wincc
i open bet i cannot simulate values and cpu tags
how i can do this
if i install plc simulator its work or not ??
any body have idea ??

SiemensFAQ · Post by **SiemensFAQ** » Wed Oct 12, 2005 10:23 am

Operating S7-PLCSIM through WinCC RT

QUESTION:
How can I operate S7-PLCSIM (RUN-P, RUN, STOP and MRES) directly from WinCC Runtime?

ANSWER:
The function can be realized in WinCC without much programming.

Proceed as follows:

Start S7-PLCSIM
Open the Graphics Designer
Add a control object
Now select the object "Siemens.S/WSPanel.1" (Fig. 1)

..............

see
http://support.automation.siemens.com/W ... n/11916587

offline · Post by **offline** » Wed Oct 12, 2005 6:14 pm

Thank you very much