[?]: connect Ultra3000 Allen-Bradley to Simatic S7

Adjuster · Post by **Adjuster** » Wed Jun 04, 2008 11:54 am

Help, please.
There are Allen-Bradley Ultra3000 2098-DSD-010X. ( http://www.ab.com/motion/servodrives/ultra3000.html )
He has a User I / O connector.
Is it possible to connect through this port I / O devices, and configure the program with support for these devices?
Is it possible to connect Ultra3000 Allen-Bradley to Simatic S7 ?

in Russian wrote:Помогите, пожалуйста.
Есть Ultra3000 2098-DSD-010X.
У него есть User I/O connector.
Можно ли через этот порт подключить I/O устройства, и настроить программу с поддержкой этих устройств? - имеется ввиду без использования контроллера - только серводвигатель с Ultra3000 БУ.

И, еще, могу ли я объединить Ultra3000 c Сименсом S7-300 (315)?
Сименс изучал, а вот Allen-Bradley пока нет .

bmller6758 · Post by **bmller6758** » Sun Jun 08, 2008 12:56 pm

Hallo,

Yes it is possible to connect them via normal I/O and analog I/O for the speed.

It is also possible to connect them over DeviceNet, if Siemens has DeviceNet

Adjuster · Post by **Adjuster** » Mon Jun 09, 2008 4:59 am

Thank you very much!
I am thinking about the I/O. -- And do.

Unfortunately Siemens have no DeviceNet protocol (or so I still do not know).

bmller6758 · Post by **bmller6758** » Tue Jun 10, 2008 8:41 pm

If you want to do it with I/O take the following Cable Set

2090 - U3BK-D4401 Breakoutboard