Hey guys,
I'm searching for an stupid HMI Software (has to run on a very small box-PC) witch has an OPC Interface or somthing similar because I'm working with Profinet (S7 and WinCC) and Modbus over TCP/IP (Momentum from Telemechanique/Schneider).
I don't want to put any logic inside this HMI - its just to show some operating buttons and some feedbacks without scaling/calculations ect.
So I'm searching for some kind of HMI software that is somehow similar to a stupid termial...
Anyone got a hint for me to crack this case?
Greetz!
[?]: Stupid HMI Software for very small box-PC ?
-
NetMare
- Posts: 6
- Joined: Fri Aug 31, 2007 12:31 pm
- Location: Europe
-
rack123
- Posts: 3
- Joined: Wed Jul 23, 2008 6:46 pm
- Location: Europe
Hello,
take a look at this:
http://www.soft-control.fr/articles.php?id=25
It's very simple but nice, tested on serial modbus RTU and seem works fine.
Mini-Scada Pro is supplied free of charge for private non-commercial use.
Any commercial or professional use requires a registered copy of the software (registration with the author).
There are other interesting software in the download section of the link above.
take a look at this:
http://www.soft-control.fr/articles.php?id=25
It's very simple but nice, tested on serial modbus RTU and seem works fine.
Mini-Scada Pro is supplied free of charge for private non-commercial use.
Any commercial or professional use requires a registered copy of the software (registration with the author).
There are other interesting software in the download section of the link above.