i downloaded the wincc flexible 2008 from the current links here 4 monthes ago, and i made more of projects on it .
but yesterday when i opened the program something was happened:
_ the program was opened after that i selected the project which i wanted to open it ... but the project wasn't accepted to open only the blue page was appeared without my project and also without any message also.
_ I tried to unistall the program by add or remove program the message was appeared.
PLEASE CLOSE THE APPLICATION WINCC FLEXIBLE , REBOOT YOUR COMPUTER AND START THIS SETUP AGAIN
_ So i made restarting for my computer and tried to unistall the program by the previous precedures also the same message was appeared again.
what can i do to repair the program or to unistall it for install it again ?????
i am going to wait your repling as soon as possible.
best regards
maher
